User`s guide

8. Close the cover. The new print head is now installed.

Step 3 - Setting the parameters of the new print head

1. Power up the printer and make sure it is properly connected to a computer

on which the Pebble (or Dualys) printer print driver is installed.

2. Under print driver “Properties”, click on the “Tools” dialogue box.

3. In the “Dialog with printer” portion, enter the following command: Pkn;x

X = the print head kit number that you read in Step 2

Example: if the print head kit number is: 379-D760 2028-D, you must enter the command:

Pkn;379-D760 2028-D

If the print head kit number is not entered correctly, printer malfunctions can occur and the

warranty may be canceled.

Step 4 - Cleaning the printer

On the LED control panel, the cleaning light comes on as follows:

Cleaning is absolutely required after a print head change.

No printing should be started before this operation has been completed.

Refer to the Clean Card Feed Module chapter to perform this operation.

Also service the cleaning roller and replace cards and ribbons.

Once the cleaning is done, your Evolis printer is again ready to personalize your cards.

UUppddaattee tthhee FFiirrmmwwaarree

5. Insert the

head vertically

into the two

uides so as

to lock the

fork lugs into

their seats.

6. Turn the print

head by

pressing the

op of the metal

piece in order

to clip it into

the spring-

ounted part.