User`s guide

Following a cleaning cycle, wait 2 minutes until all the cleaner is completely evaporated
before using the printer.
Take advantage of this interruption to clean the print head (see below).
RReeccoommmmeennddaattiioonnss
Maintenance of the card feed module ensures a high quality of printing. Evolis recommends
that you perform servicing on each ribbon change. Without waiting for the signal of the light
of the printer, proceed as described above.
30
SSeerrvviiccee tthhee cclleeaanniinngg rroolllleerr
The function of the cleaning roller is to eliminate any residual dust on the front and rear faces of the
cards before they enter the feeder system.
This roller, blue in color, therefore systematically becomes dirty. This is a sign of its efficacy.
If this roller remains clean, we suggest that you check its quality by contacting your Evolis dealer in
order to replace it, if applicable.
To supplement the servicing of the card feeder system which is intended to clean it, you can obtain
a saturated cleaning cloth and clean this component thoroughly.
Cleaning cycle: on each ribbon change
Frequency: on each ribbon change and after each cleaning cycle of the card feed module
Maintenance accessory: cleaning cloths
Proceed as follows:
1. Open the cover.
If there is one,
remove the ribbon
and locate the
cleaning roller.
2. Release
the
cleaning
roller
from its
seat.
8. Press the push button on the
control panel for a second.
The cleaning starts.
9
. The used
cleaning card is
e
jected in the
o
utput hopper.