User`s guide

26
State of the lights Interpretation Solution or explanation
■ The output hopper is midway bet-
ween open and close positions.
Close or open the output hopper.
The activity in course restarts.
■ There is a card jammed in the prin-
ting station or in the flip-over station.
■ A mechanical part in the printer is
faulty.
Press the push button for one second. If
the problem persists, call your Evolis
reseller for assistance.
■ The orientation of the magnetic
track in the feeder is not correct.
■ The type of encoding has not been
correctly parameterised (HICO or
LOCO). Go to Chapter 5 of this
manual for more information.
■ The encoded data do not conform
to ISO 7811 or to the parameters
pre-defined in the properties of the
driver. Go to Chapter 5 of this
manual for more information.
Press the push button for one second.
The printer restarts the magnetic
encoding cycle with a new card. If the
problem persists, call your Evolis
reseller for assistance.
■ The print head cooling system is
activated.
The printer stops working for a few
seconds. As soon as the print head
reaches the normal working tempe-
rature, the activity starts once more.
OUTPUT HOPPER POSITION
(Dualys only)
MECHANICAL PROBLEM
ENCODING ERROR
COOLING MODE