User`s guide

25
IInntteerrpprreettaattiioonn ooff mmeessssaaggeess
Consult the following states of the control panel to determine the activity of your Evolis printer or the nature of
the problem:
State of the lights Interpretation Solution or explanation
The printer is ready to receive data.
The printer receives data from one
or several of its interfaces.
■ There is no ribbon in the printer.
■ The ribbon has finished.
■ The ribbon has been badly installed
in the printer.
■ The ribbon is cut.
Check the state of the ribbon in the
printer. If you are have a printing job in
course, this restarts with a new card.
PRINTER READY
PROCESSING
END OF RIBBON
NO CARD IN FEEDER
OR FEEDER NOT PRESENT
WAITING FOR A CARD TO
BE INSERTED
PRINTER CLEANING
ALERT (AFTER 1000
INSERTIONS)
PRINTER CLEANING
ALERT (AFTER 1200
INSERTIONS)
PRINTER COVER OPEN
■ There is no card in the feeder.
■ The thickness of the cards has not
been correctly adjusted.
■ The cards are curved.
■ The cards are stuck together.
■ The feeder is not present in the
printer or is badly inserted.
Check the state of the cards in the fee-
der or make sure that the feeder is pre-
sent in the printer and correctly inser-
ted Then, press the push button for one
second. The printing restarts
■ The printer is waiting for a card to be
inserted.
The printer is fitted with the manual
card feeder option: insert a card in the
printer. Go to chapter 1 “Install the
Evolis printer”.
■ The printer has to be cleaned.
Go to chapter 4 “Servicing and
Maintenance”.
■ The printer has to be cleaned.
Go to chapter 4 “Servicing and
Maintenance”.
■ The printer cover is open.
Close the cover of the printer.
The activity in course restarts.