User`s guide

10
PPrree--iinnssttaallllaattiioonn aaccttiivvaattiioonn
Before installing the printer, please perform the following operations:
CCoonnnneecctt tthhee pprriinntteerr ttoo tthhee mmaaiinn ppoowweerr ssuuppppllyy
Connecting to the electrical system
T
urn off the printer by pulling the plug out of the
socket, which must always be accessible.
This product must be connected to an electrical
installation that is correctly protected and grounded.
FI: Laite on liitettävä suojamaadoitus koskettimilla
varustettuun pistorasiaan
NO: Apparatet må tilkoples jordet stikkontakt
SE: Apparaten skall anslutas till jordat uttag
1. Connect the power supply cord to the power supply, then attach the power cord connector to the printer.
2. Then connect the end of the power supply cord to a grounded system outlet.
3. The printer is under power. The light on the control panel comes on and the print head rises and
falls to indicate the correct mechanical working of the printer. If the light fails to come on, this
means that the installation has not been carried out correctly or possibly that the printer is not
working properly. Check the installation.
Prior to any maintenance action, always disconnect the power supply cable.
For your own safety, these components must remain accessible at all times to permit
emergency action
This product must be connected to a correctly protected and grounded electrical installation
CCoonnnneecctt tthhee ddaattaa UUSSBB ccaabbllee
The data cable (USB, Ethernet or other) must never be connected before the installation of the
printer driver has been completed.
Refer to Chapter 2.1 and carefully follow these instructions.