User manual

11
Open:
12
Press the cover down at the “Push”-marking until
you hear a “click”. Release the cover.
13
The Port Push is unlocked and lifts itself a few
centimeters.
14
Softly pull out the cover until the Port Push locks in
the top position.
15
Connection of devices:
Plug power and multimedia cables into the matching
outlets of the Port Push. Hold prole with your other
hand.
Close:
16
Retract the Port Push by pressing the cover to unlock
the top position. Press the retracted cover again until
it locks into ush position.
Because of the wide range of available connectors,
the retractability of the Port Push cannot be granted
for all combinations of connectors. Test carefully with
every connectors before pushing down the prole.
If Port Push unlocks too easy, adjust the screw
(see step 5).
If the Port Push was pulled out without unlocking, it
will return to its end position. Additional push on the
cover is not necessary.
Before retracting the Port Push, take care that every
connected cable is long enough.
To disconnect a cable, hold the prole with your other
hand. Do not rip out.
Cleaning instructions:
Do not use wet sponges or clothes. The surface of Port
Push can be cleaned with a slightly wet annel and
eventually some dish liquid. Do not use any corrosive
or scrubbing cleaners.
Directions for use
15 16