Specifications

19
6. Turn the heater ON
7. The heater will turn on and off according to times set in
step 4 above. If the heater reaches the HEAT/COOL TEMP
value entered in step 3 above the heat pump will turn itself
and the water pump off and wait for the water temperature
to drop by 1 degree from the set point. The heater will then
restart providing the actual time is within the set start and
stop values.
At initial startup the timer may need to be set for 24 hour run time for several days to al-
low the heat pump to heat the pool to the desired temperature.
The operation time of the heat pump may also need to be adjusted from winter to sum-
mer to ensure adequate time to heat the pool.
In the PARAMETER menu please DO NOT modify any of the following values unless
specically advised by Evoheat – DEF CYC, DEF IN, DEF OUT, DEF TIME, SYSTEM,
SAVE, TYPE.
Programmed Options – “Auto” Mode.
This mode allows the user to set their desired water temperature and heater will automatically
maintain it and allows your heater to run at various times of the day and night depending on
conditions, by controlling the dedicated water circulation pump. See below for further infor-
mation.
Use your pool at any time day or night at your set temperature. Set the heater on auto mode
and walk away and forget about it! This means the heater will operate as required at various
times of the day and night. Optimum heater performance is achieved when the air tempera-
tures are at their maximum. This option provides the ultimate in convenience and maximises
your return from your pool investment.