User manual

Chapter 1 Product Introduction
EC7-1817LNAR - 3 -
 VGA supports 2048x1536@75HZ, 32bit color depth in maximum; Display port
supports 2560x1200@60HZ in maximum; DVI and HDMI support
1920x1200@60HZ in maximum.
Network Function
Provides one 10/100/1000Mbps LAN port, supporting Wake-on-LAN, LAN PXE
booting and AMT7.0 functions. To enable the LAN wake-up function, please enter the
AMT setting interface to configure the relevant AMT parameters first. Please set as
follows:
A. Modify the parameters in [Intel ME General Settings]\[Power Control]\[Intel ME
On in Host sleep states] to: Mobile: ON in S0, ME Wake in S3, S4-5 (AC only);
B. Choose “Activate LAN Wake-up Function” in [Intel AMT Configuration].
Audio Function
Supporting HDA CODEC and MIC-in/Line-in/Line-out function.
Power Feature
Adopts single 12V Adapter power input, brought out various status power on-board;
supports ACPI function and S0, S1, S3, S4, S5, Deep Sleep S4, Deep Sleep S5 and
AMT7.0 functions.
Two ways to test the DSW function (Deep sleep S4/S5):
a) Enter via pressing “CTRL+P” --> Input the ME password--> Intel ME General
settings --> Power control --> Intel ME ON in host sleep states--> Choose Mobile:
ON in S0. Save and exit ME finally. Enter the M_off status after powering off the
computer.
b) Short JP2 via jumper cap and disable ME.
c) Press the POWER BUTTON to power off the computer after save the setting.
Measure VCC5SB via ammeter, at that time the power on VCC3SB has been disabled
while the power on VCC3_3DSW remains. That is to say the system has entered
DSW status.