User manual

Chapter 2 Installation
- 18 - EC7-1817LNAR
J5(LAN1)
LILED
(Dual-Color: O/G)
LAN Speed
Indicator
ACTLED
(Green)
LAN Activity
Status Indicator
Green 1000Mbps
Blink Data Transmitting Orange 100Mbps
Off No Data to Transmit Off 10Mbps
Switch
The board provides one PWR Button switch (SW1) and one reset switch (SW2).
GPIO Connector
Pin Signal Name Pin Signal Name
1 GPIO1 2 GPIO5
3 GPIO2 4 GPIO6
5 GPIO3 6 GPIO7
7 GPIO4 8 GPIO8
GPIO1
(Pitch: 2.0mm)
9 GND 10 NC
Note: the pins for GPIO are bi-directional signals. To facilitate test and
application, the factory default value is that Pin1, 3, 5 and 7 are for TTL input
while Pin2, 4, 6 and 8 are for CMOS output. The factory default status is high
level while the voltage range for IO signals is 0-5V.
Fan Connector
The board provides one 1x4Pin CPU fan (CPUFAN1, Pitch: 2.54mm) and one 1x3Pin
system fan (SYSFAN1, Pitch: 2.54mm). Pay attention to the following three issues
when using the fan socket:
 The current for fan shall not exceed 700mA (12V);