User manual

Chapter 2 Installation
EC7-1817LNAR - 15 -
Power Connector
Pin Signal Name
1 +12V
2 +12V
3 GND
PWR1
4 GND
Pin Signal Name
1 +12V
2 GND
3 GND
PWR2～PWR5
Pitch: 2.54mm
4 +5V
SATA Connector
The board provides four SATA sockets and the pin definitions are as follows:
Pin Signal Name
1 GND
2 TX+
3 TX-
4 GND
5 RX-
6 RX+
SATA1/SATA2
SATA3/SATA4
7 GND
Hot-swap of SATA Hard Disk
Notices for hot-swap of SATA hard disk:
1. The hard disk shall support SATA 2.0 and use 15-pin SATA hard disk power
connector.
2. The driver of chipset shall support the hot-swap of SATA hard disk.
3. Hot-swap of SATA hard disk with the operating system is forbidden when system
is powered-on.