User manual

Chapter 2 Installation
- 8 - EC7-1817LNAR
Jumper Setting
1. JCC1: Clear/Keep CMOS Setting (Pitch: 2.54mm)
CMOS is powered by the button battery on board. Clearing CMOS will restore
original settings (factory default). The steps are listed as follows: (1) Turn off the
computer and unplug the power cable; (2) Instantly short circuit JCC1; (3) Turn on
the computer; (4) Follow the prompt on screen to enter BIOS setup when booting the
computer, load optimized defaults; (5) Save and exit. Please set as follows:
Setup Function
1-2 Open Normal (Default)
JCC1
1-2 Short
Clear the contents of CMOS and all BIOS settings
will restore to factory default values.
2. JM1: Clear/Keep ME Register Setting (Pitch: 2.54mm)
Setup Function
1-2 Open Normal (Default)
JM1
1-2 Short
Clear the contents of ME RTC register and all the
settings will restore to factory default values.
3. JP1: Enable the Operating Voltage of LVDS and Embedded Panel (Pitch:
2.54mm)
Setup Function
1-2 Short Enabled LVDS Voltage (Default)
JP1
2-3 Short Enabled EDP Voltage
4. JP2: SPI Flash Safety Performance Setting (Pitch: 2.54mm)
Setup Function
1-2 Open
Enable ME function and disable on-line refresh
BIOS. (Default)
JP2
1-2 Short
Disable ME function while enable on-line refresh
BIOS.
Note: when short circuit JP2 (1-2), ME is disabled; an error prompt of “The system
doesn’t comply with the minimum requirement to install the software” will appear
when installing the AMT driver; therefore, before installing the ME driver, please set
the jumper cap of JP2 to “OFF” so as to enable ME.