User manual

BIOS Setup
- 26 - EC3-1816CLD2NA(B)
 SATA
Aptio Setup Utility – Copyright (C) 2012 American Megatrends, Inc.
Advanced
SATA Port0 Not Present
SATA Port1 Not Present
SATA Controller(S) [Enabled]
Configure SATA as [IDE]
SATA Port Mode as [mSATA Device]
HDD Latency Time [Disabled]
→←：Select Screen
↑↓：Select Item
Enter：Select
+/-：Change Opt
F1：General Help
F2：Previous Values
F3：Optimized Defaults
F4：Save
ESC：Exit
Version 2.16.1226. Copyright (C) 2012,American Megatrends, Inc.
SATA Port0 ~ 1 dynamically detect whether there are SATA devices on the
motherboard. If devices are connected with the corresponding ports, then it will
display the SATA device type. Otherwise, it will display “Not Present”.
 SATA Controller(S)
SATA controller is used to enable or disable devices on SATA Port.
 Configure SATA as
To configure the type of SATA settings: IDE or AHCI.
 SATA Port Mode as
To select whether SATA interface is used for mSATA device or CF card.
 HDD Latency Time
Used to increase HDD detection time during power-on.