User manual

Installation Instructions
- 10 - EC3-1816CLD2NA(B)
Pin Signal Pin Signal
1 Red 2 Green
3 Blue 4 NC
5 GND 6 GND
7 GND 8 GND
9 NC 10 GND
11 NC 12 DDCDATA
13 HSYNC 14 VSYNC
VGA1
15 DDCCLK
Note: Due to Intel GMA driver limitation, the CRT may become extended mode or
not have signal to it (the CRT is secondary display) after restarting from the graphics
driver installation. To work out this limitation, press the Ctrl+Alt+F1 hotkey to switch
the CRT mode to primary display.
2. LVDS port
This board provides one dual-channel 24bitLVDS port (LVDS1, LVDS2; pitch:
1.0mm). If single-channel 18-bit/24-bit LVDS screen is used, LVDS data cable must
be connected to LVDS1. The pin definitions of dual-channel 24-bit LVDS are as
follows:
Pin Signal Pin Signal
1 LVDSO_D0+ 2 LVDSO_D0-
3 GND 4 GND
5 LVDSO_D1+ 6 LVDSO_D1-
7 GND 8 GND
9 LVDSO_D2+ 10 LVDSO_D2-
11 GND 12 GND
13 LVDSO_CLK+ 14 LVDSO_CLK-
15 GND 16 GND
17 LVDSO_D3+ 18 LVDSO_D3-
LVDS1
19 VDD 20 VDD