User manual

Chapter 3 BIOS Setup

EC3-1813CLD2NA(B) - 29 -

 AHCI Port0 ~ 2

Configuration menu for AHCI port, it is displayed only when the SATA

controller is configured to AHCI or RAID.

*SATA Port0 ~ 2

Auto: automatic detection of SATA devices when powering on;

Not Installed: disable the port and detection.

*S.M.A.R.T

Used to set whether to enable S.M.A.R.T function and it is only effective for the

hard disk supporting this function.

 Super IO Configuration

BIOS SETUP UTILITY

Configure SCH311X Super IO Chipset

OnBoard Floppy Controller [Enabled]

Serial Port1 Address [3F8]

Serial Port1 IRQ [IRQ4]

Serial Port2 Address [2F8]

Serial Port2 IRQ [IRQ4]

Serial Port3 Address [3E8]

Serial Port3 IRQ [IRQ3]

Serial Port4 Address [2E8]

Serial Port4 IRQ [IRQ3]

Parallel Port [378]

Parallel Port [Normal]

Parallel Port [IRQ7]

Allows BIOS to Enable or

Disable Floppy Controller.

 Onboard Floppy Controller

Used to enable the floppy driver controller.