installation and_manual

INSTALLATION INSTRUCTIONS
A f f i n i t y 3 0 G
Evo, Inc., 20560 SW 115th Ave., Tualatin, OR 97062 USA
Phone [phone] | Fax [phone] | www.evoamerica.com | [e-mail]
25
CHECKING GAS LEAKS (LP)
Do not ignite burners or use an open fl ame to check for gas leaks. Be sure there are no sparks
or open fl ames in the area while you check for gas leaks. Flames and sparks will result in a fi re
or explosion which can cause serious bodily injury or death and damage to property.
DANGER
Note: All factory-made connections have been thoroughly checked for gas leaks.
The burners and ignition system has been fl ame tested. As a safety precaution, we
recommend you recheck all fi ttings for leaks before using your Evo grill. Shipping and
handling may loosen or damage a gas fi tting.
To perform a leak check you will need a solution of soap and water and a brush or rag to
wet all gas connections.
1. Turn all control knobs to the OFF position.
2. Turn on gas supply and check for leaks by wetting the connections with the soap and water
solution and watching for bubbles. If bubbles appear, or if a bubble grows, there is a leak.
Note: Since some leak test solutions, including soap and water, may be slightly
corrosive, all connections should be rinsed with water after checking for leaks.
WARNING
Perform leak checks even if your grill was
dealer or store assembled.
You should check for gas leaks every time
you disconnect and reconnect a gas fi tting.
WARNING
CHECK ALL GAS CONNECTIONS:
1. Hose to Regulator.
2. Regulator to Gas Supply connection.
PLEASE POST THESE INSTRUCTIONS IN A PROMINENT LOCATION