User Manual

Mount or dismount front wheel
For easy transport, you may remove the front
wheel using the quick release at the front wheel
axle (Only Tui and Falcon).
To remove the wheel flip the lever into the open
position. Now hold the lever and turn the bolt
on the other side about 8-9 times to loosen the
axle – do not remove the bolt! You should be now able to lift the wheel out of
the fork.
To mount the wheel repeat procedure the other way round. Guide the rotor in
between the brake pads. Hold the lever pointing parallel to the fork in the open
position (downwards), turn the bolt till you feel a slight resistance. Try to close
the lever – if it is too hard to do so, loosen the bolt a bit and try again.
Before every ride make sure the quick release is tightened
properly. To fail so can lead to serious injuries!
Adjust the stem and handlebar
The models TUI+ and FALCON+ allow an
easy and tool free adjustment of the
handlebar in regard of angle and reach.
Push lock lever in direction of arrow and lift
clamp arm. Adjust height and angle to your
requirements. Push clamp arm back into
lock position.
The clamp pressure can be adjusted with an
Allen key.
Make sure to lock the
clamp arm properly
Check tire pressure
It is very important to maintain the correct tire pressure. Too low pressure will
decrease the range and can lead to rim or tire damages when riding over
edges. The recommended tire pressure is 40 psi.
11