Manual

23
22
O M E N
™
2.0 EVIL DETONATOR DIAG R A M
O M E N
™
2.0 BOARD PROGRA M M I N G
01 Detonator End Cap 57201
02 Detonator Adjusting Ring 57202
03 Inner Tube 57203
04 Regulator Seat 57204
05 Thrust Element 57205
06 Seal Retainer 57206
07 Detonator Main Body 57207
08 Piston Spring 57208
09 Piston 57209
10 Snap Ring 57210
11 Locking Screw 10/32 Oval Point 57211
12 O-Ring 011/70 Buna 57212
13 O-Ring 008/90 Urethane (Poppet O-ring)
40923
14 Retaining Screw 8/32 Dog Point 57213
15 O-Ring 012/90 Urethane 40919
1 6 10/32 Black Lower Locking Scre w 41318
17. Detonator Regulator 57200
actual size
TURN POWER ON WITH TRIGGER PULLED AND
HELD IN
WAIT FOR LED TO COME ON
(ABOUT 2 SECONDS)
RELEASE TRIGGER
Electronic Trigger Sensitivity
PULL THEN RELEASE, PULL AGAIN AND
HOLD
WAIT FOR LIGHT TO TURN OFF THEN RELEASE TRIGGER
5 TO 25 BALLS PER SECOND
1 TO 50 POINTS
WHILE COUNTING CLICK THE TRIGGER AND HOLD IT IN ON THE DESIRED
SETTING UNTIL THE LED GOES OFF. RELEASE THE TRIGGER AND ONCE THE LED IS ON
STEADY, THE VALUE HAS BEEN SAVED AND IT’S READY TO FIRE.
BALLS/SEC
PULL TRIGGER AND
HOLD
OMEN 2.0 Board Programming
OMEN 2.0 Parts Kit
(18102)
1/8” Hex Key 42026
3/32” Hex Key 42033
1/16” Hex Key 42036
Omen Hammer Cushion 57712
O-ring 15/70 Urethane 57738
O-ring 19/70 Buna 57728
Omen Manual 2.0 6/21/05 9:56 AM Page 22