User's Manual
EVIL
®
MINION
™
TRIGGER ADJUSTMENT
AND ON/OFF AIRPORT
• Be sure the trigger screw is not adjusted
too far. The switch is sensitive and may
cause accidental discharge of the marker.
• Removing the trigger spring will cause
premature wear on the micro switch,
resulting in failure.
• Be sure you do not pinch the wires between
the frame and body when reattaching the
frame to the body.
WARNING
Figure 1
7
www.evil-paintball.com
ADJUSTING YOUR TRIGGER
The trigger’s forward travel and over travel are fully adjustable so that the user can fine-tune the
trigger to his or her exact liking.
• Remove the grip frame from the body of the EVIL
®
MINION
™
.
• As you pull the frame away from the body, take care so as not to damage the wires
running between the two parts. Be careful not to lose the trigger spring.
• The two adjustment screws are located at the top of the trigger in the grip frame.
(See figure 1)
• Use a 5/64” Allen wrench to make the desired adjustments.
• The screw toward the front of the trigger controls the forward travel. Screwing it in
will shorten the trigger’s length of pull. NOTE: If this screw is adjusted too far, the switch
will be held down and the marker will fire once when turned ON and will not fire
when trigger is pulled.
• The screw toward the rear of the trigger controls the over travel. By turning this screw
you can adjust how far the trigger will travel after it reaches the firing point.
NOTE: If this screw is adjusted too far, the trigger will not be allowed to travel far enough to
depress the switch and fire the marker.
• When the desired trigger pull has been achieved, reattach the frame to the body.
• Take care that the spring is seated properly. Using the trigger without a spring is not
recommended and will cause the micro switch to fail much sooner than when a spring
is used.
• Be sure that all wires are laid properly in their appropriate cavities.
NOTE: Be sure that the frame and trigger assembly are kept clean. If there is excess dirt or paint build
up around the trigger, the trigger will no longer move freely. In addition, paint and dirt can cause the
micro switch to not function properly or fail.
ON/OFF AIRPORT
The EVIL
®
MINION
™
comes equipped with an On/Off
Airport attached to the bottom of the frame. To turn on
the gas supply, twist the on/off knob clockwise, all the
way in. To turn the gas supply off, twist the on/off knob
counterclockwise, all the way out. As you turn the knob
out, the residual gas between the Hyper2
™
and the
On/Off Airport is vented.
REMOVING THE ON/OFF AIRPORT
1 Follow the instructions on page 6 to remove the
battery from the frame.
2 Using a 3/32” Allen key, turn the airport locking
screw counterclockwise until the On/Off Airport is
loosened.
3 Slide the On/Off Airport off of the frame
4 To re-install the On/Off Airport, follow steps 1-3 in
reverse order