User's Manual

ManualsBrandsEvil ManualsPaintballEvil Minion

Air Supply - The EVIL

MINION

™

should be operated using air/nitrogen gas only. This air needs to be supplied to the Hyper2

™

in-line regulator

at a regulated pressure of no more than 850 psi. The Hyper2

™

in-line regulator comes factory preset at 185psi.

Gassing Up Your EVIL

MINION

™

- Screw in your air system to the on/off airport and turn the airport knob clockwise, all the way in.

Turning On Your EVIL

MINION

™

- The EVIL

MINION’s power is controlled by two buttons. The top button turns the marker on and off, while

the bottom button turns the eye on and off. Hold the power button for 3 seconds to turn the marker on. The LED in the grip will illuminate

during the boot sequence.

NOTE: If the eye is not working properly, try replacing the battery.

Orange - Boot sequence

Red - Breech is clear, no ball (eye on)

Green - Ball in breech, ready to fire (eye on)

Blinking Red - Eyes are off

Blinking Green - Eye failure (see EVIL

MINION

™

Board, page 4)

LPR - The LPR is pre-set from the factory at approximately 75-80 psi and should need

no adjustment out of the box. If fine tuning adjustment is desired or needed, you

must be sure that you are adjusting the LPR correctly. See page 10 for detailed

instructions. If the LPR is improperly adjusted, you could dramatically hinder the

MINION’s performance or prevent the marker from functioning at all.

NOTE: Turning the adjustment screw clockwise, or in, will lower the LPR’s output pressure.

Turning the adjustment screw counterclockwise, or out, will raise the LPR’s output

pressure.

Hopper - To get the best performance out of your EVIL

MINION

™

it is recommended that you use a motorized loader.

Preferably one that force feeds the paint really, really fast!

Adjusting Velocity - The velocity is adjusted through the Hyper2

™

in-line regulator.

The Hyper2

™

in-line is preset from the factory at approximately 185 psi.

This pressure setting should have the marker shooting at about 285 fps.

Your paint-to-barrel fit will also have a noticeable affect on your velocity.

Make sure that the paintball fits into the barrel loosely but does not drop through.

NOTE: For the Hyper2

™

, turning the adjustment screw clockwise, or in, will lower

the output pressure, decreasing the velocity. Turning the adjustment screw counterclockwise,

or out, will raise the output pressure, increasing the velocity.

NOTE: If the battery is too low, it may not be able to power the solenoid correctly.

This will affect your EVIL

MINION’s velocity, causing it to become inconsistent and/or low.

QUICK REFERENCE

USING YOUR EVIL

MINION

™