User's Manual

15
www.evil-paintball.com
• Turn on the EVIL
®
MINION
™
, the light should be red after the boot up
sequence. If it is the eyes are working.
• Check that the eye wire is connected to the board so that metal clips are
facing down.
• If nothing above helps contact a store or EVIL
®
Paintball for eye
replacement.
SOLENOID WILL NOT ACTIVATE / TRIGGER NOT WORKING
• Check that the trigger adjustment is not set so that the micro switch
cannot activate. You should hear a small click when pulling the trigger.
• If the EVIL
®
MINION
™
fires once when turned on but not after that your
trigger is set so that the micro switch is always activated. Re-adjust the
trigger.
• If the trigger is correctly adjusted but the EVIL
®
MINION
™
still won’t fire
check that the micro switch cable is well inserted into the board and to
the correct connector (the micro switch connector is marked with the text
“SWI” on the board).
• Change the battery.
• Check that the solenoid cable is attached to the board and to the right
connector (solenoid should be attached to the connector that is marked
with the text “SOL”).
TRIGGER BOUNCE / EVIL
®
MINION
™
SHOOTING MORE THAN ONE BALL PER
PULL IN SEMI AUTOMATIC MODE
• Raise the trigger sensitivity level in the configuration mode.
• Check that the trigger is not adjusted too short.
• Make sure there is a trigger spring inside the frame.
ERRATIC VELOCITY / EVIL
®
MINION
™
WON’T FIRE
EVIL
®
MINION
™
FIRES BUT BALLS ARE DROPPING OFF OR NOT EVEN
COMING OUT OF THE BARREL
• Make sure the battery is good.
• Raise the dwell to factory level (25).
• Make sure bolt is well lubed and moves well. If there is too much friction
in the bolt it will cause the EVIL
®
MINION
™
to shoot down.
• Make sure air system is screwed in all the way.
FIRST SHOT IS TOO HIGH
• Change the Seat inside the Hyper2
™
regulator. For dis-assembly
instructions consult the technical section.
• Check that the #013 O-ring on the outside of the Manifold is in place
and in good condition.
• Try turning off the ABS feature by turning dip #1 to the off position.
VELOCITY IS NOT CONSISTENT
• Make sure the paintballs you are using fit the barrel well and are
consistent in size. The stock barrel with the EVIL
®
MINION
™
is .690 size.
• The paintball should be able to blow through the barrel with but they
should not roll through the barrel on their own.
• Remove the bolt kit and re-lube it. Change any O-rings causing a lot of
friction. Make sure #014 O-ring in bolt tip is in place and in good
condition.
• Raise the dwell.
• Change the battery.
• Check that the Hyper2
™
regulator is working well and that the pressure
is consistent. A separate regulator testing tool is available for this.
If needed, disassemble and change worn out O-rings in the Hyper2
™
regulator.
OTHER CATEGORIES
DOUBLE FEEDING
• If two balls are firing at once, change the ball detents by removing
the eye plates, taking out the old ball detents and inserting new ones.
BREAKING PAINT
• Make sure you use high quality paintballs and that they are stored
according to the manufacturers instructions.
• Check that #14 O-ring on bolt tip is in place and in good condition.
• Make sure your loader is working well and that the rate of fire is not
set higher than the maximum feed rate of the loader.
• Check that the barrel you are using is not too tight for the paintballs you
are using.