User's Manual

EVIL
®
MINION
™
FUSE
™
BOLT
ASSEMBLY + MAINTENANCE
BOLT MAINTENANCE
Regular EVIL
®
MINION
™
Fuse
™
bolt maintenance is vital to the performance of the EVIL
®
MINION. If the Fuse
™
bolt is not kept well-greased and
the O-rings in good shape, the performance of the EVIL
®
MINION will be greatly hindered. NOTE: Use of the included EVIL
®
PUS
®
or Slick Lube lubricant
is highly recommended.
To remove the bolt, you will need a 1/4” Allen wrench. Unscrew the bolt from the rear of the marker. It only takes one and one half revolutions to
unscrew the bolt so that it can be pulled out. After the bolt has been cleaned and greased and is ready to be inserted into the body, be sure all bolt
sleeve components are screwed together snugly. Slowly push the bolt into the body. Take care not to cut or nick the O-rings as they pass the threads.
GREASE THE EVIL
®
MINION
™
FUSE
™
BOLT EVERY 5-10 THOUSAND SHOTS.
NOTE: BEFORE INSTALLING THE BOLT INTO THE MARKER, BE SURE ALL BOLT SLEEVE COMPONENTS ARE
SCREWED TOGETHER SNUGLY.
If you do not grease the bolt, you will run the risk of damaging O-rings. This will create excessive friction and drag on the bolt, ultimately resulting in
breaking of the bolt. When greasing the EVIL
®
MINION
™
Fuse
™
bolt, pay special attention to all O-rings that are on the bolt and that ride on a surface of
the bolt. The first seven O-rings listed below should be generously greased during maintenance.
FUSE
™
BOLT O-RING LIST
1 Bolt tip (014 BN70) 6 Top hat (017 UR70)
2 Bolt sail (015 BN70) 7 Top hat (013)
3 Inside bolt stem (009 BN70) 8 Outer sleeve (020 BN70)
4 Rear bolt stem (009 BN70) 9 Front bumper (015 BN70)
5 Front wall internal (017 UR70) 10 Rear bumper (111 BN70)
NOTE: All remaining O-rings should have a thin coating of grease as well.
1
2
9
10
3 4
5
7
6
88 8 8 8
9
www.evil-paintball.com