Owner's Manual

EVIL DETONATOR

OWNER'S MANUAL

The EVIL DETONATOR represents a new standard for Second Stage regulators.

It's standard .825-14 NGO interface, and 1/8 NPT inlet make it an almost

universal fit on currently available Markers. It's virtually non-existent Response

Curve makes it the only logical choice for today's High Tech, Low Pressure

tournament grade equipment!

PAGE 1
EVIL DETONATOR OWNER'S MANUAL The EVIL DETONATOR represents a new standard for Second Stage regulators. It's standard .825-14 NGO interface, and 1/8 NPT inlet make it an almost universal fit on currently available Markers.
PAGE 2
SPECIFICATIONS Weight Length (@ max press setting) Range of Adjustment (Output) Maximum Input Pressure Response Curve Inlet Port Outlet Port ADJUSTMENT To adjust Output pressure on the Detonator, first loosen the locking screw (using a 3/32” Allen key) in the Adjusting Collar. It is not necessary to remove this screw, but it does have to be turned out at least two turns in order to clear the detent pocket it engages.
PAGE 3
ROUTINE SERVICE There are only three wear items that will eventually require attention. The first is the piston Oring, which is a standard 015 series urethane ring. If this ring wears, you will experience leakage around the adjusting collar. To replace this ring, remove the snap ring, and gently remove the piston assembly from the reg body. No other disassembly is required. Be sure to lube the new Oring with airgun or air tool oil, and to replace the snap ring when re-assembling.
PAGE 4
PAGE 5
15 13 ITEM NO. QTY. 1 1 2 1 3 1 4 1 5 1 6 1 7 1 8 1 9 1 10 1 11 1 13 1 14 1 15 1 16 1 12 1 13 1 14 1 15 1 16 1 17 1 14 9 8 17 7 PART NO.