® A USB VGA Display Port Quick Install Guide Supports UV 12, UV 16 and UV 19
Introduction EVGA’s UV Plus+ gives you the ability to use multiple displays by utilizing a USB 2.0 port on your laptop or PC. Each monitor will need either a UV 12, UV 16 or UV 19. Up to 6 UV Plus+ devices can be used at the same time allowing multiple displays through CRT and LCD monitors, or a Projector. With the ability to Mirror or Extend your desktop up, down, left, or right, EVGA’s UV Plus+ gives you full freedom to move about your virtual work space. System Requirements: • An available USB 2.
The Following Resolutions are Supported: Resolutions may vary depending on your displays capabilities. DVI connection • 800x600, 1024x768, 1280x768, 1366x768, 1280x1024, 1440x900, 1400x1050 Supported on UV 12, UV 16, and UV 19 • 1680x1050, 1600x1200 Supported by UV 16 and UV 19 models only • 1920x1200, 2048x1152 Supported by UV 19 model only Hardware and Driver Setup: DVI to VGA Adapter 1 – Power on your Laptop or your monitor and PC to begin the installation.
FAQ: Question: Will the UV Plus+ attached monitor render full 3D hardware rendered graphics when in Mirror or Extended Modes? Answer: Yes, full 3D hardware rendered graphics can be displayed while in Mirror or Extended Modes, however running in such a configuration is limited as the application in use may become slower or not as responsive. Question: Discoloration and constant flickering occurs through the UV Plus+ attached monitor.
