User manual

PCoIP Multi-Monitor Deployment Guide
TER0905009 Issue 2 16
3 Other Considerations
This section outlines other options for a multi-monitor deployment.
3.1 Auto-Reconnect
The Auto-Reconnect feature automatically reconnects PCoIP sessions when they are
disconnected by either network or power issues without user interaction.
Enabling Auto-Reconnect
1. On the management PC, browse to Portal A using the static IP address configured in
Section 1.4.
2. Log in and select the Configuration->Session menu item. The Session webpage is
shown in Figure 3-1.
Figure 3-1: Portal Session Configuration Web Page
3. Click on the Enable Auto-Reconnect check box to enable the Auto-Reconnect option.
4. Select Apply to update the Portal.
5. Repeat Steps 1-4 for Portal B.
3.2 Remoting More Monitors
Quad monitor PCoIP deployment instructions are discussed in Section 1. In addition, you
can use more PCoIP Host/Portal pairs to remote more monitors. For example, Portal A
and Host Card A; Portal B and Host Card B; Portal C and Host Card C, and etc.
Note: Before you add more Host/Portal pairs to remote more monitors, be sure that the
additional graphics cards installed to the host PC can properly drive multi-monitors.
If no free PCIe slots are available in the PC, you can use the PCoIP Host Card in
Standalone Mode. Refer to Section 2.2 for more information on Standalone Mode.