User manual

PCoIP Multi-Monitor Deployment Guide
TER0905009 Issue 2 10
b. Step 2: Uncheck Enable DHCP and enter the IP address you want to use
for Portal A, for example, 192.168.1.202. Enter Subnet Mask (e.g.
255.255.255.0) and Gateway (e.g. 192.168.1.1).
c. Step 3: Select PCoIP for Session Type and Identify Host by IP address.
Enter Host A’s static IP address and MAC address, e.g. 192.168.1.200
and AA-AA-AA-AA-AA-AA.
d. Select Apply to accept the changes made. You can restart the Portal
5. Configure Portal B by repeating Steps 1-5 except using Portal B’s new IP address,
e.g. 192.168.1.203 and Host Card B’s networking information, e.g.
192.168.1.201 the BB-BB-BB-BB-BB-BB. Also, if you want audio, enable it only
on Portal A.
6. On the management PC, browse to Host Card A using the DHCP IP address
determined in Step 1 above.
7. Log in and select the Configuration->Initial Setup menu item. The Initial Setup
webpage for the Host Card is shown in Figure 1-3.
Figure 1-3: Host Card Initial Setup
8. Configure Host Card A using the Initial Setup webpage:
a. Step 1: If using audio, enable HD audio (only enable Vista 64-bit mode if
using Windows Vista 64.)
b. Step 2: Uncheck Enable DHCP and enter the IP address you want to use
for Host Card A, for example, 192.168.1.200. Enter Subnet Mask
(e.g. 255.255.255.0) and Gateway (e.g. 192.168.1.1).
c. Step 3: Be sure Accept Any Portal is enabled. (If you disable Accept Any
Portal, you must enter Portal A’s MAC address.)