User manual

PC-over-IP Administrative
Interface User Manual
63
2.3.5.4 Session Timeout
The Session Timeout configures the timeout for a connection. If the PCoIP processor
does not detect a network within the timeout period, the PCoIP processor will disconnect
the session.
2.3.6 Bandwidth Tab
The Bandwidth tab allows the administrator to limit the Portal bandwidth.
Note: The Bandwidth can also be configured using the Webpage Administration
Interface. See Section 1.6.6 Bandwidth.
Figure 2-9: Bandwidth
2.3.6.1 Device Bandwidth Limit
The Device Bandwidth Limit parameter defines the maximum bandwidth peak for the
PCoIP system. The bandwidth setting on the Host side defines the bandwidth from the
Host to the Portal (e.g. graphics data) and the Bandwidth setting on the Portal side
defines the bandwidth from the Portal to Host (e.g. USB data). The usable range of the
maximum device bandwidth is 3 to 220 Mbps.
The PCoIP processor will continue to use only the bandwidth required up to the Device
Bandwidth Limit maximum. The PCoIP processor will dynamically adjust the bandwidth in
response to network congestion.
Setting the Device Bandwidth Limit to 0 configures the PCoIP processor to adjust the
bandwidth depending on network congestion. If there is no congestion, there will be no
limit; i.e. the PCoIP processor will use the maximum rate available.
We recommend setting the Device Bandwidth Limit to the limit of the network connected
to the Portal and Host.