User manual

PC-over-IP Administrative
Interface User Manual
59
2.3.2.6 Secondary DNS Server
The Secondary DNS Server field is the device’s secondary DNS IP address. This field is
optional. If DHCP is enabled, this field is not editable. This field must be a valid IP
address; if an invalid IP address is entered, the OSD will prompt the administrator to
correct it.
2.3.2.7 Ethernet Mode
The Ethernet Mode field configures the Ethernet mode of the Portal. The options are:
• Auto
• 10 Mbps Full-Duplex
• 100 Mbps Full-Duplex
Note: Administrators should always set the Ethernet Mode to Auto and only use 10
Mbps Full-Duplex or 100 Mbps Full-Duplex when the other network equipment, e.g.
switch, is also configured to operate at 10M Mbps Full-Duplex or 100M Mbps Full-Duplex.
2.3.3 Connection Management Tab
The Connection Management tab allows the administrator to enable or disable
connection management and to specify the IP address of the connection manager.
In a managed connection, an external Connection Manager Server communicates with
and can remotely control and configure the device. Additionally, the connection manager
can locate an appropriate peer for the device to connect to and initiate the connection.
Connection management can greatly simplify the administration effort for a large,
complex system.
Note: The Connection Management parameters can also be configured using the
Webpage Administration Interface. See Section 1.6.3 Connection Management.
Figure 2-6: Connection Management Configuration