User manual

PC-over-IP Administrative
Interface User Manual
42
1.8.1.2 Event log filter mode
The Event log filter mode pull-down menu allows the event log to be filtered. The options
are:
Verbose
Terse
1.8.2 Session Control
The Session Control webpage allows control of the device session.
Figure 1-29: Session Control Webpage
1.8.2.1 Connection State
The Connection State field reports the current state of the session. Values are:
Disconnected
Connection Pending
Connected
Below the Connection State field there are two buttons, Connect and Disconnect.
Connect
If the Connection State is Disconnected, selecting this button causes the Portal to initiate
a PCoIP session with its peer device. If the Connection State is Connection Pending or
Connected, this button is disabled.
This option is only available on a Portal; on the Host it is disabled and non-editable.
Disconnect
If the Connection State is Connected or Connection Pending, selecting this button causes
the device to end the PCoIP session. If the Connection State is Disconnected, this button
is disabled.
1.8.2.2 Peer IP/MAC Address
Peer IP Address
The Peer IP Address reports the IP address of the peer device. When not in session, the
field is blank.