User manual

PC-over-IP Administrative
Interface User Manual
35
1.6.12.2 Enable NTP
The Enable NTP field allows the administrator to enable and disable the NTP feature.
1.6.12.3 Identify NTP Host By
The Identify NTP Host by selector allows the administrator to choose whether the NTP
Host is identified by IP address or by Fully Qualified Domain Name (FQDN). If NTP is
disabled, this field is not required and is not editable.
Table 1-8 shows the configuration parameters available when either method is chosen. If
an invalid IP address or DNS name is entered, the web interface will prompt the
administrator to correct it.
Table 1-8: NTP Host Method
Method Data Fields
IP address
NTP Host IP Address
FQDN
NTP Host DNS name
1.6.12.4 NTP Host Port
The NTP Host Port field configures the NTP port number.
1.6.12.5 NTP Query Interval
The NTP Query Interval fields allow the administrator to configure the query interval. The
first field denotes the interval period and the second field denotes the time unit in
Minute(s), Hour(s), Day(s) and Week(s).
1.6.12.6 Time Zone
The Time Zone field allows configuration for the local time zone.
1.6.12.7 Enable Daylight Savings Time
The Enable Daylight Savings Time field allows the administrator to enable and disable
automatic adjustment for daylight savings time.
1.6.13 Password
The Password webpage allows the administrator to update the local administrative
password for the device. Note that this will affect the web interface and the local GUI.
The password can be a maximum of 20 characters.
Note: Care must be taken when updating the Portal Password as the Portal may become
unusable if the password is lost.
Note: The Portal Password can also be updated using the Portal OSD. See Section 2.7
Password.