Specifications

8-pin ATX 12V Power (PWR2)
PWR2, the 8-pin ATX 12V power connection, is used to provide power to the CPU. Align
the pins to the connector and press firmly until seated.
It is strongly recommended that you use an 8-pin ATX 12V power supply; however a four-pin
power supply may be used. The 8 pin power connection is keyed for either a 4 pin or 8 pin
connector to only go in one way.
Connecting IDE Hard Disk Drives
The IDE connector supports Ultra ATA 133/100/66 IDE hard disk drives.
Connect the cable end with a single connector to the motherboard.
If you install two hard disk drives, you must configure the second drive as a slave device by
setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings.
Connecting Serial ATA Cables
The Serial ATA II connector is used to connect the
Serial ATA II device to the motherboard. These
connectors support the thin Serial ATA II cables for
primary storage devices. The current Serial ATA II
interface allows up to 300MB/s data transfer rate.
There are four serial ATA connectors on the motherboard that
support RAID 0, RAID 1, RAID 5, and RAID 0+1
configurations. (610i motherboards support RAID0 or RAID1
only)
Connecting Internal Headers
Please refer to item 10 in figure 1 Motherboard.
Front Panel Header
The front panel header on this motherboard is one
connector used to connect the following four cables:
 PWRLED
Attach the front panel power LED cable to the PWR LED connector. The Power LED
indicates the system’s status.