Product specifications
Table Of Contents
- Cover Page
- Table of Contents
- Overview
- Product Specifications
- Chapter 1
- Chapter 2
- Chapter 3
- Entering BIOS Setup
- BIOS Setup Main Menu
- Standard CMOS Features
- Advanced BIOS Features
- Advanced Chipset Features
- Integrated Peripherals
- Power Management Setup
- PnP/PCI Configuration
- PC Health Status
- Clock/Voltage Control
- Load Standard and Optimized Defaults
- Set Supervisor/User Passwords
- Save & Exit Setup/Exit Without Saving
- Chapter 4
- Chapter 5
- Chapter 6
39
Figure 3.8
Onboard Super IO Function
The following information is provided as a reference for the Onboard
Super IO Function of the BIOS. Below is an illustration of the menu for
this section. See Figure 3.8.
Onboard FDD Controller
Select Enabled if the system has a floppy disk controller (FDD) installed
and will be used. If an add-on Floppy Disk Controller will be installed or
the system has no floppy drive, select Disabled. Set this function to one
of the configuration options: Enabled or Disabled.
Onboard Serial Port 1/Port 2
Select an address and a corresponding interrupt for the first and the
second serial ports. Set this function to one of the configuration options:
3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled or Auto.
UART Mode Select
This function allows the user to select an operating mode for the second
serial port. The configuration settings for this item are Normal, IrDA,
ASKIR or SCR.
IR Duplex Mode – This feature becomes available when either
IrDA or ASKIR is selected. The available options for this setting are
Full or Half Duplex.
Onboard Parallel Port
Select the LPT port address and corresponding interrupt for the physical
parallel port. Set this function to one of the configuration options:
Disabled, 3BC/IRQ7, 278/IRQ5 or 378/IRQ7.