Product specifications
Table Of Contents
- Cover Page
- Table of Contents
- Overview
- Product Specifications
- Chapter 1
- Chapter 2
- Chapter 3
- Entering BIOS Setup
- BIOS Setup Main Menu
- Standard CMOS Features
- Advanced BIOS Features
- Advanced Chipset Features
- Integrated Peripherals
- Power Management Setup
- PnP/PCI Configuration
- PC Health Status
- Clock/Voltage Control
- Load Standard and Optimized Defaults
- Set Supervisor/User Passwords
- Save & Exit Setup/Exit Without Saving
- Chapter 4
- Chapter 5
- Chapter 6
30
Year (yy): Change this value to the appropriate year.
Time
The time format is as follows (Military Time is represented here):
Hours (hh): Change this value to represent the appropriate time,
hours. The range for value is 00 through 24.
Minutes (mm): Change this value to the appropriate time, minutes.
The range for this value is 00 through 59.
Seconds (ss): Change this value to the appropriate time, seconds.
The range for this value is 00 through 59.
IDE Channel
0 Master
0 Slave
1 Master
1 Slave
2 Master
3 Master
Navigate to each of the appropriate drives for configuration. Once
selected, hit ENTER to bring up the IDE Channel configuration menu.
From there, the IDE HDD Auto Detection function can be used to
detect and setup the selected drive pressing the ENTER key.
Each channel can also be setup individually by navigating to the IDE
Channel 0 Master, or which ever drives is being setup at the time. In
this example 0 Master was selected. Use the PgUp /PgDn keys to
configure the hard drive(s). The values for this setting are Manual, Auto
and None.
Note: The specifications of the hard drive must match with the drive
table within the BIOS. The hard disk(s) will not work properly if incorrect
information is set for this selection. If the hard disk drive type is not
matched or listed, use the Manual option to define the hard drive type.
If the Manual option is selected, necessary related information must be
provided. Enter the information directly from the keyboard. This
information should be provided in the documentation from the hard disk
vendor or the system manufacturer.
If the controller of HDD interface is SCSI, the selection will be
None.
If the controller of HDD interface is a CD-ROM, the selection will be
None.