Product specifications
Table Of Contents
- Cover Page
- Table of Contents
- Overview
- Product Specifications
- Chapter 1
- Chapter 2
- Chapter 3
- Entering BIOS Setup
- BIOS Setup Main Menu
- Standard CMOS Features
- Advanced BIOS Features
- Advanced Chipset Features
- Integrated Peripherals
- Power Management Setup
- PnP/PCI Configuration
- PC Health Status
- Clock/Voltage Control
- Load Standard and Optimized Defaults
- Set Supervisor/User Passwords
- Save & Exit Setup/Exit Without Saving
- Chapter 4
- Chapter 5
- Chapter 6
20
Floppy Drive Connector
Pin 1
FDD
Primary IDE
Connecto
r
Pin 1
IDE1
FDD: Floppy drive Connector (34-pin block)
This connector supports the 3 ½ inch floppy drive ribbon cable. Use the
cable provided to connect the floppy drive to the system motherboard.
IDE1: Primary IDE Connector (40-pin block)
This connector supports the IDE1 hard disk ribbon cable. Use the cable
provided to connect the primary hard drive to the system motherboard.
Note: If two hard disks are installed, the second drive must configured
as a slave by setting its jumpers accordingly. Please refer to the
documentation of the hard disk for the correct jumper settings.