Product specifications
Table Of Contents
- Cover Page
- Table of Contents
- Overview
- Product Specifications
- Chapter 1
- Chapter 2
- Chapter 3
- Entering BIOS Setup
- BIOS Setup Main Menu
- Standard CMOS Features
- Advanced BIOS Features
- Advanced Chipset Features
- Integrated Peripherals
- Power Management Setup
- PnP/PCI Configuration
- PC Health Status
- Clock/Voltage Control
- Load Standard and Optimized Defaults
- Set Supervisor/User Passwords
- Save & Exit Setup/Exit Without Saving
- Chapter 4
- Chapter 5
- Chapter 6
14
Valid Memory Configurations:
Installing DDR SDRAM modules in to the motherboard is generally
easy; however, if you need assistance, refer to the illustration below.
Note: When you install DIMM modules fully into the DIMM socket,
the eject tab should be locked into the DIMM module and fit into its
indention on both sides.
WARNING: The DDR SDRAM CLOCK is set at 200MHz; use only
DDR400 compliant DDR Modules. If non-compliant DIMM modules
are used, the system may not boot because of the strict timing
requirements. If the DDR Modules are not DDR400 compliant, set
the SDRAM clock to 133MHz to ensure system stability.
Bank 184-pin DDR DIMM PCS
Total Memory
Bank 0, 1
(DIMM1)
DDR266/DDR333/DDR400
DDR DRAM Module
X1 64MB∼1.0GB
Bank 2, 3
(DIMM)
DDR266/DDR333/DDR400
DDR DRAM Module
X1 64MB∼1.0GB
Total
System Memory (Max. 2.0GB)
X2 64MB∼2.0GB
DIMM2 (BANK2+BANK3)
DIMM1 (BANK0+BANK1)