Safety Information

EverWatt Lights GHS Format SDS
Preparation Date: 06/03/2014 Revision Date: 10/08/2017
Format: GHS Language: English (US) WHMIS, OSHA HCS 2012
Page 2 of 11
Section 1: Identification (Continued)
LED Surface Mounted Luminaire, Model(s) EW-SMSB-300W-XYZA1 - Where "X" stands for LED manufactory, could be any alphabet , Where "Y"
can be "T1" to "T9", represents different Diffuser light angle type employed, Where "Z" can be any two bit letter representing the type of Mounting
bracket employed (e.g. AM= ADJUSTABLE FITTER MOUNTING, DM= DIRECT MOUNTING, YM= YOKE MOUNTING, FM=FLOOD Mounting, IM=
Type E bracket or TM= Type F bracket.)
LED Surface Mounted Luminaire, Model(s) EW-SMSB-300W-XYZH1-X Where first "X" stands for LED manufactory, could be any alphabet ,
Where "Y" can be "T1" to "T9", represents different Diffuser light angle type employed, Where "Z" can be any two bit letter representing the type of
Mounting bracket employed (e.g. AM= ADJUSTABLE FITTER MOUNTING, DM= DIRECT MOUNTING, YM= YOKE MOUNTING, FM=FLOOD
Mounting, IM= Type E bracket or TM= Type F bracket.) The last "X" represent CCT, can be 2500-7000K
Relevant identified uses of the product:
Recommended use: Intended for use outdoors, can be used as a street light area light or flood light.
Details of the supplier of the safety data sheet
Manufacturer: EverWatt Lights
Address: 5221 Central Ave. #5 Richmond, CA 94804, United States
Email: [e-mail]
Phone: [phone]
Website: www.EverWattlights.com
In emergency situations contact local authorities.
Section 2: Hazard Identification United States (US)
Hazard Classification: Inert, Article
Section 2.Hazards Identification
NOTE:
EverWatt LED fixtures are electronic devices. When used as intended, do not have any special health or safety hazards. As a service to
customers, this SDS does provide information about hazards that may result if the products are damaged, broken, abraded, or reduced
in size by mechanical means or if the products are used improperly. Grinding, cutting, sanding and/or other manipulation of this
product may change and alter the hazards and information listed in all of the following sections in ways that cannot be predicted.
2.1. Hazard Classification: Inert, Article
2.2. OSHA Regulatory Status:
This product, when intact, is not known to be hazardous as defined by OSHA’s Hazard Communication Standard, 29 CFR 1910.1200. This
product is exempt from OSHA’s Hazard Communication Standard requirements for an MSDS because it meets the definition of an
“article”. An article is a manufactured item: (1) which is formed to a specific shape or design during manufacture (2) which has end use
functions dependent in whole or in part upon its shape or design during end use: and (3) which does not release, or otherwise result in
exposure to, a hazardous chemical under normal conditions of use. Any product which meets the definition of an “article” is exempt from
the requirements of the Standard.