Installation Manual

Installation Method 2: Yoke Mounting
1. To install the fixture with a yoke mount, loosen the fixing screw on the cap.
Take the cap off.
2. Loosen the fixing bolt and affix the fixture to the support. Tighten the fixing
bolts (figure 2).
3. Feed the AC wire to through the hole in the support and connect it.
4. Close the cap and tighten the fixing screw after placing the AC cable in the
support (figure 2).
5. To adjust the fixture, loosen the adjusting screws, align the fixture to the
desired angle and then fasten the screws (figure 2).
Installation Method 3: Direct Mounting (Pre-installed Holes)
1. To install the fixture with a direct/arm mount, open the side lid of the
direct bracket and feed the wire of the fixture through the direct bracket
(Figure 3).
2. Fix the direct bracket to the end of the lamp body with the bolt (Figure 4).
3. Feed the wire from the lamp pole through the hole of the pole and then
into the direct bracket (Figure 5).
4. Fix the direct bracket to the lamp pole with the bolt (Figure 6).
5. Connect the wires from the pole to the wires of the fixture (Figure 6).
6. Make sure the wires are protected and properly connected, then push the
wires into the direct bracket. Close the side lid and then tighten it (Figure
7).
7. Note: 1: If you are installing the fixture on a round pole, the adapter plate
is required (Figure8).
8. Note 2: if installing on a pole without pre-existing holes, use 8-10mm size
drill bit to pre-drill the holes.
Installation Method 4: Direct Mounting (U-brackets)
1. Use an electric drill to drill holes on the poles or the suspended walls. (The
hole pitch should be according to the actual application of products, and
the hole size should be same as the screw the user has) (Figure 9).
2. Put the installation bracket on the pole position and then using screws and
nuts, fix the light tight. Adjusting to the desired light angle (figure 10).
3. Connect the wire of the lamp to the mains and make sure there is good
protection on the connection.
4. Put the wire into the pole, and cover the pole cover.
5. Tighten the side screws (figure 10).