Installation Guide

to fit the contour of the floor. Use crown moulding to cover any gaps that occur between the
top of the planks and the ceiling or follow the contour of the ceiling leaving an 1/8" gap for
expansion.
Step 3: Chair Rail Trim (sold separately from planks) Optional Step
Cut the chair rail to measured length and apply adhesive to the back. Place the chair rail over
the planks so that the groove fits on top of them. Leave a 1/8 inch gap at the top between the
planks and the chair rail trim to allow for expansion and contraction. Make sure that the chair
rail is level before nailing into studs. If joining two pieces of trim end-to-end, it is recommended
that they each be trimmed at a 45 degree angle to create a seamless appearance. Apply bead of
caulk along the top, inner edge of the trim to fill in any exposed gaps.