Specifications

- 1 -
SA370-2
Z-Wave 700 USB DONGLE
1. Introduction
The SA370-2 is a Z-Wave Plus USB adapter to turn the PC or gateway into
a Z-Wave controller to manage multiple devices in the Z-Wave network. It’s
fully compatible with any Z-Wave enabled network. Z-Wave enabled
devices displaying the Z-Wave logo can also be used regardless of
manufacturer. A Sigma driver “CP210x VCP Drivers” and third party
software are required to operate this device. A PC / notebook running Z-
Wave software can control Z-Wave network through this USB.
Note: This is a hardware transceiver only. Third party software needs to
be installed on your computer before using them as a Z-Wave Gateway.
2. Appearance
Figure 1 SA370-2 Appearance
3. Installation
Plug the USB dongle into your PC or notebook and install all necessary
drivers and software.
Troubleshooting
Possible Cause
Solution
Unable to Pair
Device is controlled
incorrectly.
See the device menu and
check the pairing
procedures.
RF signal interference.
Operate again when there
is no interference.
Pairing successful, but the
device cannot be
controlled or the device
report cannot be received.
The maximum distance
between the USB dongle
and the device has been
exceeded.
Shorten the distance
between the USB dongle
and device.
RF signal interference.
Operate again when there
is no interference.
Specifications
Frequency Range
908.4MHz/916Mhz
Operating Temperature
Range
-10 to 50°C (Indoor use only)
Storage Temperature
Range
-20 to 60°C
Humidity
85%RH
Interface
USB
Operating Range
Up to 100m line of sight
www.everspring.com
50 Sect. 1 Zhonghua Rd Tucheng
NewTaipeiCity 236 Taiwan..