User's Manual

2
Figure 6 European Version
Figure 7 American Version
Figure 7 American Version
Step 2: Install Receiver Unit
(Two visions available: European and American)
European Version (refer to Figure 6):
To connect receiver to your TV:
1. Plug the 1M Scart connector cable that package
included into your TV.
2. Plug the other end, yellow (video), white (audio) and red
(trigger) RCA connectors into the corresponding RCA
connectors on the receiver.
American Version (refer to Figure 7):
To connect receiver to your TV:
1. Plug the yellow (video) and white (audio) RCA connectors
into TV socket.
2. Plug the yellow (video) and white (audio) RCA connectors
into the corresponding RCA connectors on the receiver.
Step 3: Install option accessory VCR Controller (refer to
Figure 6 or Figure 7)
By adding the optional VCR Controller (C755) will enable the
system to automatically record anyone who approaches your
premises. The VCR Controller will automatically switch your
VCR on to Record and Off once the person has left.
Plug RJ45 connector of VCR Controller (C755) in AUX outlet of
the receiver, and VCR will record the images and voices when
Camera detects movement. (Please refer to C755 manual for
installation and operation).
Operating Instruction:
(1) Buzzer/Light ON/OFF SW: Select “ Buzzer/Light SW” at
"ON". When PIR camera is triggered, image and voices will
be transmitted. Upon receiving the signals, the receiver
sounds “ Beep” twice in response and the LED will flash for
1 minute.
(2) Transmission time (lock time) of image and voices can be
set as 10, 20, 30, or 40 seconds by carefully adjusting the
“ DWELL_SW (SW3)” knob of Camera.
(3) When lock time of trigger is over, the camera will continue
transferring image and voices if PIR sensor is still under
triggered condition. Otherwise, the camera will send an
“ OFF” signal to the receiver and shut down images and
voices.
(4) When PIR of the camea is triggered, the camera will send
2.4GHz RF signal to the receiver. Thus, images and voices
will be displayed on TV or monitors through the receiver.
(5) When battery is low:
a. In the condition of camera on, Camera sends a signal to the
receiver to lighten the “ Battery” LED and sound two “ beeps”
for alert.
b. If battery is low during image transmitting, the image will
stay on for 5 seconds only. Then there will be two beeps
and the “ Battery” LED will be on.
(6) If the camera battery is recharged to normal level, the low
Battery LED will be turned off when the camera is triggered
again.
You can also additionally have a 9V DC 300mA regulator power
AC adapter and wire it on S3 (refer to Figure 3) of backplate to
recharge and to transmit images and voices continuously.
Note:
(1) What you should do when the camera does not work properly:
a. Unscrew the camera (two screws on the edge of front cover)
b. Press “ SW1” on Wall Mount to restore the system
c. Turn off the receiver, then turn it on.
d. Hang the camera on Wall Mount, and tighten 2 screws on
the bottom of the camera.
(2) When battery is low, video automatically reduces to 5
seconds to save battery.
(3) Position the receiver and set up channel first while installing,
then position the camera and set receiver in the same
channel with the camera.
(4)When the image on TV is not clear, it means that somebody
may use the same channel as yours in your neighborhood.
You can change both channels on the backplate of camera
and the receiver. Remember to set the camera in the same
channel as that of the receiver.