User Guide

Getting Started Steps
Steps 1 and 2 take you up to the point of sensor
insertion. Schedule an appointment with your
healthcare provider to have the sensor inserted.
After insertion, you will need to wait 24 hours to
perform the first set of calibrations and start
receiving glucose readings onyour app.
To get started you need:
• A compatible mobile device (like your smartphone)
– For a list of compatible devices, visit
https://global.eversensediabetes.com/
compatibility.
• Wireless internet connection
• Eversense
XL Smart Transmitter
Charging the
Smart Transmitter
After you receive your smart transmitter it must be
fully charged before pairing with the app.
• Plug the standard end of the USB cable into the
adapter on the USB port.
• Plug the micro end of the USB cable into the
charging cradle on the USB port.
• Line up the four gold pins
on the bottom of the smart
transmitter with the four
gold pins on the charging
cradle. Once fully charged
(about 15 minutes), a
small green light appears
on the top side of the
smart transmitter. Remove
the USB cable from the
charging cradle after it is
fully charged.
Note: If you press the power button on the smart
transmitter and no LED appears, press and hold the
power button for about 5 seconds to turn it on.