Installation Guide

scan QR code
to see FasTread
™
installation
animation
FLOOR
EXISTING
CARPET
RISERS
TREAD
TREAD
STRINGER
.
FLOOR
STRINGER
NOSING
TREAD
EXISTING
RISER
EXISTING
RISER
TREAD
FLOOR
WIDTH
HEIGHT
TREAD
MEASURE
FRONT VIEW
FLOOR
STRINGER
TREAD
EXISTING
RISER
FLOOR
wall
wall
WIDTH
DEPTH
BOTTOM TREAD
TOP OF REPLACEMENT RISER
MEASURE
TOP VIEW
TOP VIEW
DEPTH
DO NOT INCLUDE NOSING WIDTH
(AREA SHOWN IN RED)
WHEN MEASURING TO CUT DEPTH
AB
STRINGER
EXISTING
TREAD
INSTALL
FasTREAD
Reversa-Riser
8
12866 02676
2


STURDY RED OAK CONSTRUCTION
STURDY RED OAK CONSTRUCTION


FITS MOST STANDARD STAIRWAYS
FITS MOST STANDARD STAIRWAYS


PERFECT FOR STAIR REMODELS
PERFECT FOR STAIR REMODELS


INSTALLS WITH COMMON CARPENTRY TOOLS
INSTALLS WITH COMMON CARPENTRY TOOLS


INTERIOR USE ONLY
INTERIOR USE ONLY


COMPATIBLE WITH OUR
COMPATIBLE WITH OUR
REVERSA-RISER!
REVERSA-RISER!
Check local building codes in your area for staircase design requirements. Purchaser bears full responsibility for building code compliance.
1
2 3 4
5 6 7
8
Remove existing carpet and all nails,
glue, and debris. All surfaces should
be smooth.
Using a saw, cut the nosing from the
bottom tread so it is ush with the riser.
Be careful not to damage stringers
or walls.
Measure width and height of existing
bottom riser. Be sure to include the
existing tread thickness in height
measurement.
Cut a new riser (sold separately) to
dimensions from Step 3. Install over
existing riser using construction
adhesive and 2" 18-gauge pin nails.
Measure depth (front to back including
replacement riser thickness) and width
(left to right) of existing bottom stair
tread. Use these dimensions to cut
FasTread
Make sure depth starts from inside edge
of nosing (A) and goes towards the back
of the FasTread (B)
Apply 1/4" bead of construction
adhesive according to pattern above,
going around perimeter half-inch from
edge of tread.
Place FasTREAD over existing tread
and position in place. Nail each corner
down with 2"/18 gauge pin nails, or #13
x 2" finish nails. Pre-drill to help prevent
cracking if using a hammer to nail in
place. Repeat process on remaining
treads.
GLUE
PENCILSCREW DRIVERTAPE MEASUREHACK SAW
ALLEN
WRENCH
HAMMER
SAFETY
GLASSES
LEVEL
CHOP /
MITER SAW
CAULK GUN
CONSTRUCTION
ADHESIVE
POWER DRILL,
DRILL BITS
FINISH NAILS,
ANCHORS
SPRING BOLT /
RAIL BOLT KIT
PENCILSCREW DRIVERTAPE MEASUREHACK SAW
ALLEN
WRENCH
HAMMER
SAFETY
GLASSES
LEVEL
CHOP /
MITER SAW
CAULK GUN
CONSTRUCTION
ADHESIVE
POWER DRILL,
DRILL BITS
FINISH NAILS,
ANCHORS
SPRING BOLT /
RAIL BOLT KIT
Lorem ipsum
EM RED EM BLUE
EM YELLOW EM GREEN
EM LIGHT
BLUE
EM BLACK
INSTALLATION INSTRUCTIONS BELOW:
Tools Needed: Saw, tape, hammer, drill, construction adhesive (PL100 or
equivalent), 2"/18g pin nails for air nailer, or #13x2" finish nails