Assembling & Installation Instructions

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
1. Disconnect power at main electrical panel before
installation. Remove old fixture and all hardware from
Junction Box.
2. Attach the mounting plate to the junction box using two
junction box screws as shown. The side of the mounting
plate marked “GND” must face out. The junction box is
not included.
3. Guide fixture wires through hole in center of mounting
plate.
4. Follow wiring instructions carefully (see fig.2)
5. Attach the candle sleeve(C) insert the lamp holder, attach
the crystal shim(B) to the lamp holder. Raise the
diamonded crystal(D) hang to the bottom small ring of the
lamp body.
6. Install the light bulbs in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!
7. Attach the fixture body (A) over the mounting plate，
aligning the back plate holes with screw hole of the
mounting plate on side, then lock it securely with
mounting screw.
Wiring (see fig.2)
1. Connect the electrical wires as follows. Connect the
Black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the white
(neutral) house wire. Make sure all wire nuts are secured.
You may wrap the connections with electrical tape. If
your outlet box has a ground wire (green or bare copper)
connect fixture’s ground wire to it. Otherwise attach the
bare copper fixture wire to the green ground screw on the
mounting plate.
2.Tuck the wire connections neatly into the wall junction
box.
Fig.1
Mounting plate
Junction Box
Supply Ground Wire
Supply wire
Box screw
Fixture Ground Wire
Mounting screw
A
B
C
D
(Not included)
Fig.2
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
ASSEMBLING & INSTALLATION INSTRUCTIONS
For Wall Mount Light Fixture