Datasheet

Everlight Electronics Co., Ltd. http://www.everlight.com Rev 3 Page: 7 of 10
Device No
：DTR-012-001 Prepared date：09-03-2008 Prepared by：Jaine Tsai
IR12-21C/TR8
4.Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3
seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more
intervals, and do soldering of each terminal. Be careful because the damage of the product is often
started at the time of the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is
unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed
beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.