Datasheet

LifecyclePhase:
Revision : 2
Expired Period: Forever
Release Date:2011-01-21 18:00:13.0
22-23C/R6GHBHW-C01/2C
Everlight Electronics Co., Ltd. http://www.everlight.com Rev. 2 Page: 13 of 13
Device No. : DSE-0001583 Prepared date: 21-Jan-2011 Prepared by: Esther Yan
4.Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within
once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of the
hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether
the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD. Tel: [phone]
Office: No 25, Lane 76, Sec 3, Chung Yang Rd, Fax: [phone]
Tucheng, Taipei 236, Taiwan, R.O.C http://www.everlight.com