Manualshelf

Full Product Manual

ManualsBrandsEverlast ManualsMulti Process Welders250 Amp LightningMTS 275 IGBT Digital Inverter AC-DC MIG/TIG/Stick Multi-Process Welder, HF/Lift TIG Start, 240-Volt
71727374757677787980
71
SIDE PANEL FEATURES
1. Spool Carrier. The spool carrier is designed to carry full-size spools of wire 12” in diameter, and up to
44 lbs. It can also be used with the supplied adapter to carry 8” diameter spools with the supplied
adapter. Hint: With some brands of smaller 8” rolls the adapter locating pin may be too long to t
properly. Take a le, or small grinder or saw and take off a small amount of the locating pin until the
spool fully seats and the door is able to close without rubbing.
2. MIG/Flux-Cored Polarity. This is where the gun polarity is changed. Work Clamp polarity is changed on
the front of the panel. For MIG, the cable should be connected to the positive (+) terminal. For Flux-
Cored, the cable should be connected to the negative terminal.
3. Four Roll Drive Feeder. The wire feeder features 4 driven rolls. Only the bottom feature removeable
rolls. Drive rolls must be matched to the size and type of wire being fed. Order additional drive rolls
from Everlast if needed.
4. Panel Door. This door should be kept closed while in use to prevent access to moving parts.
SIDE ACCESS PANEL LIGHTNING MTS 275
Section 2 Setup Guide