Full Product Manual

Section 2 Setup Guide

SETTING UP WELDING PARAMETERS

SELECTION OF SPOT/STITCH CONTROL

To activate the spot/stitch timer and adjust the settings:

1. Press and release one of the arrow buttons until the Spot/Stitch Timer segment of the pinwheel menu has been highlighted.

2. Press the settings button (gear icon) to access the 4-way secondary menu.

3. Press and release one of the arrow buttons to highlight and select either “Spot/Stitch On” or “Spot Off”. Once the timer has

been turned on, continue to press and release the arrow button to highlight the desired parameter (Spot or Stitch).

4. Once the desired parameter has been selected, use the top right knob to adjust the value of the parameter.

5. To exit the 4-way menu and return to the main pinwheel menu, press and release the home (house icon) button.

NOTICE: If Spot only is desired, set the stitch timer to 0.0 S. Do not set Stitch time without setting a spot time. Turning the Spot/

Stitch timer on will limit access to control functions. If you are loading another spool or installing a new gun or xing a feeding

issue, turn the Spot/Stitch timer off. The Spot/Stitch timer, if it is on during this process will stop the feeding of the wire when the

timer has timed out. This may mean that only a few inches of wire are fed at a time before the wire stops feeding. If you are expe-

riencing on/off or cycling of the wire feeding, check to make sure the Spot/Stitch timer is not turned on.