Full Product Manual

56
Section 2 Setup Guide
SETTING UP WELDING PARAMETERS
SELECTION AND ADJUSTMENT OF MIG/FLUX-CORED PARAMETERS
In all MIG and Flux-Cored wire modes, use both top and bottom knobs to control both Wire Feed Speed and Voltage. The top
knob controls Wire Feed Speed and the bottom knob controls Voltage, when in the default position. When the right or left arrow
button is pressed, and a segment in the pinwheel is highlighted, the WFS will not longer be highlighted red and adjustment of the
WFS will not be possible. The WFS box will change to gray, preventing the top knob from controlling the WFS. However, the
Voltage, will always be able to be adjusted regardless of the highlighted function (as long as the unit is still in the main pinwheel
menu, and not the 4 way menu). The Voltage box will always be colored gray and is only controlled by the bottom knob.