Full Product Manual

55
Section 2 Setup Guide
SETTING UP WELDING PARAMETERS
SELECTION AND ADJUSTMENT OF MIG/FLUX-CORED PARAMETERS
1. Once the process has been selected, use the right or left arrow button to select the desired parameter for adjustment. The
selected parameter on the pin wheel will be highlighted in red, indicating this parameter is ready for adjustment.
2. Rotate the top right knob to increase or decrease the parameter value.
3. For items such as Control and Spot/Stitch, the user will need to press and release the settings (gear icon) to access the sec-
ondary 4-way menu to adjust the parameters or change method of operation. Press the home (house icon) button to return
to the main pinwheel menu.
NOTICE: One pinwheel segment OR WFS box will always be highlighted. The default highlighted position is the Wire Speed Feed
(registers in Inches Per Minute/IPM). This allows the top knob to control any highlighted parameter value. It is not necessary to
return to the Wire Feed Speed position to weld, but it is a good idea to do so. This will allow on-the-fly adjustment of Wire Feed
Speed.