Full Product Manual

CONNECTIONS AND POLARITY

AC TIG ONLY! (GTAW-AC)

SWITCH

GAS

PEDAL

WORK (AC TIG ONLY)

NOTICE:

The water cooler is optional and

must be purchased separately.

Water cooled torches must be

used with water coolers and

cannot be used dry.

TO COOLER

FROM COOLER

TORCH -

CONTROL

Section 2 Setup Guide

NOTICE:

The foot pedal and the torch switch cannot be connected at the same time. The torch switch may remain attached to the torch, but since they

both use the control connection and serve a similar purpose only may be used at a time. The torch depicted is a water-cooled torch and the

diagram depicts proper connection for water-cooled torches. Do not use this torch without a water cooler or torch damage will occur. To deter-

mine the gas line blow through the lines with compressed air. Improper connection will result in no gas flow or water coming out of the torch

head. The Everlast Coolers are designed to be powered from the 240V plug in the rear of the unit. Use only TIG rated coolant in the cooler.