Manualshelf

Full Product Manual

ManualsBrandsEverlast ManualsMulti Process Welders250 Amp LightningMTS 275 IGBT Digital Inverter AC-DC MIG/TIG/Stick Multi-Process Welder, HF/Lift TIG Start, 240-Volt
21222324252627282930
27
CONNECTIONS AND POLARITY
DC TIG ONLY! (GTAW-DC)
WORK +
PEDAL
SWITCH
CONTROL
TO COOLER
FROM COOLER
GAS
NOTICE:
The water cooler is optional and must
be purchased separately. Water cooled
torches must be used with water cool-
ers and cannot be used dry.
TORCH -
NOTICE:
The foot pedal and the torch switch cannot be connected at the same time. The torch switch may remain attached to the torch, but since they
both use the control connection and serve a similar purpose only may be used at a time. The torch depicted is a water-cooled torch and the
diagram depicts proper connection for water-cooled torches. Do not use this torch without a water cooler or torch damage will occur. To deter-
mine the gas line blow through the lines with compressed air. Improper connection will result in no gas flow or water coming out of the torch
head. The Everlast Coolers are designed to be powered from the 240V plug in the rear of the unit. Use only TIG rated coolant in the cooler.
Section 2 Setup Guide